推广 热搜: 开关  钛白粉  油墨  钢板  润滑油  液晶显示器  展会  喷枪    磁选机 

红绿双色激光舞台灯,带三脚架 KTV激光灯

 
规格1: 规格1未填写
规格2: 规格1未填写
规格3: 规格1未填写
单价: 面议
起订: 1 台
供货总量: 10000 台
发货期限: 自买家付款之日起 1 天内发货
所在地: 广东 深圳市
有效期至: 2012-11-07 [已过期]
最后更新: 2012-11-15 09:07
浏览次数: 1041
 
公司基本资料信息
详细说明
 配  

1.激光灯1台   2.交流适配器 1个   3.说明书 1份 4.三脚架 1个

  

电源:交流适配器输入AC110-240V/50-60HZ,输出5.0V/1A

激光图形:满天星(红+绿)

波长/功率:532nm/50mW(绿) ,650nm/100mW(红)

尺寸:130x92x52mm

净重:0.6KG

注意事项

1.严格按本操作说明书所述规程操作, 请勿擅自拆卸灯具。

2.本产品仅适用于室内使用, 并确保防水、防潮、防震,勿在多尘环境中使用。

3.基于半导体激光器特性, 要求工作环境温度为15~30℃,连续工作两个小时候后, 需关闭灯具10分钟,激光器会完全冷却。

4.防止异物进入机体内, 以免导致故障。

5.请勿频繁开关, 以免影响激光灯使用寿命, 并尽量避免长时间开启。

6.避免用远望设备观察激光光源, 这样可能增大危险。

7.再次运输时,请注意防震,最好使用原包装。

警 告

1.本灯具激光危险等级为Class III B, 直接在光束内观察有危险。

2.该灯具对电源要求110-240V/50-60HZ,若超出此范围, 建议使用稳压设备, 否则将严重影响激光寿命。

  

   本产品在出厂时己经过全面严格的检测,使用者应严格遵守以上所陈述的警告事项和操作说明,任何因误用而导致对产品的损坏不在本公司保修范围之内, 对忽视操作手册而导致的故障和问题亦不在经销商负责的范围内,任何操作产生的激光对人体损害,本公司不负责任。

Fittings

1. Laser light 1 set 2. AC adapter 1 3. Manual 1 4. Tripod 1

Specifications

Power: AC adapter input AC110-240V/50-60HZ, output 5.0V/1A

Laser graphics: stars (red + green)

Wavelength / Power: 532nm/50mW (green), 650nm/100mW (red)

Size: 130x92x52mm

Net Weight: 0.6KG

Notes

1. In strict accordance with procedures described in the instruction manual operation, do not disassemble lamps.

2. This product is only suitable for indoor use, and to ensure that water, moisture, shock, do not use in dusty environments.

3. Based on semiconductor lasers, the working environment required temperature 15 ~ 30 ℃, continuous two hours later, take off lights for 10 minutes, the laser will cool down completely.

4. To prevent foreign matter into the body, so as not to cause trouble.

5. Please do not often switch, so as not to affect the life of the laser light and to avoid prolonged open.

6. Avoid afar observe laser light source device, which may increase the risk.

7. Again transport, please note that earthquake, it is best to use the original packaging.

Warning

1. The laser light risk rating for the Class III B, to observe directly in the beam is dangerous.

2. The lights on the power requirements 110-240V/50-60HZ, if out of this range, it is recommended to use voltage regulator device, otherwise it will seriously affect the laser life.

Statement

   This product has been fully rigorous factory testing, the user should strictly comply with the above stated warnings and operating instructions, due to misuse of any product damage caused is not within the scope of our warranty, instruction manual and on the neglect of failures and problems are not caused by the dealer within the responsibility of any action on the human body generated by the laser damage, the company responsible.

反对 0举报 0 收藏 0 评论 0
更多>本企业其它产品
网站首页  |  关于我们  |  服务条款  |  广告合作  |  付款方式  |  使用协议  |  联系我们  |  网站地图  |  排名推广  |  广告服务  |  网站留言  |  RSS订阅  |  违规举报