推广 热搜: 开关  钛白粉  油墨  钢板  润滑油  液晶显示器  展会  喷枪    磁选机 

激光舞台播放器,遥控音响机

 
规格1: 规格1未填写
规格2: 规格1未填写
规格3: 规格1未填写
单价: 面议
起订: 1 台
供货总量: 1 台
发货期限: 自买家付款之日起 1 天内发货
所在地: 广东 深圳市
有效期至: 2012-11-08 [已过期]
最后更新: 2012-09-14 09:26
浏览次数: 1034
 
公司基本资料信息
详细说明
 操作说明

1 接上DC12/2A电源,按电源ON/OFF,2秒后按镭射ON/OFF

 

2 MP3播放/暂停:按第一次“mp3播放/停止”键播放MP3音乐;按第二次暂停当前的音乐播放,按二次INPUT键能接收多频道收音,调频用播放上/下首音乐键,可用遥控器调收音。

      

3、播放器按操作播放上/下首音乐。

    

4、点均速移动,按此按键第一次,MP3音控模式(激光会随音乐的节奏而闪烁)

    

5USB:产品通过USB连接线,拷贝MP3音乐数据(可当U盘使用)有外制音频输入3.5 mm接口

      

6、遥控器:使用遥控器时,需将遥控器对准产品上的遥控接收器,有效控制距离约10米,产品上的遥控接收器的有效接收角度为15度,超出此角度将会影响遥控效果;使用遥控器调节音量时,需将产品音量调到最大声,这样才能正常遥控音量大小。

    

7 第一次使用遥控器时,需将透明垫片取出方可使用。

    

使用场所可为

家庭舞会 生日聚会   结婚庆典   迪厅   KTV等各种娱乐场所营造浪漫气氛用。

    

产品规格

1 产品外形尺寸:19.5*15.5*24.5CM彩盒外形尺寸:42*25*38CM   重量:1.8KG

   

2 包装配件:(1)音乐舞台灯1台(2)AC电源一个(3)遥控器一个(4)使用手册一份(5)音频线、电源线各1条

   

3 电源:输入100~240V AC 50/60Hz,输出:5V DC 1.5A,可用车载点火器电源,和摩托车12V电源输入。

   

4 扬声器:3寸半全频,2寸高音

   

5 扬声器功率:15W

                                                                                      

6、工作温度:+10度~+40度

   

7、存储温度:-10度~+60度

 

常出故障处理

1、满天星光点模糊:请用棉签轻擦出光口镜片即可。

   

2、按播放时没有声音:按关闭电源ON/OFF,再次打开电源ON/OFF,3秒钟以后再打开音乐播放键,然后把音量控制键调在中间或最大声状态即可。

   

注意事项

1. 严格按使用手册所述对产品进行操作,擅自拆卸不保修。

   

2. 本产品使用时请注意防水 防潮 防震以及不要在多尘的环境中,镭射的正常工作环境温度为10~40度,超出此温度范围,镭射光可能出现异常。

   

3. 请不要用眼睛直视镭射光,避免使用远望设备和光学设备观察镭射光源,以防止增大危险性。

   

声明

1. 所以使用者必须遵守所有手册和注意事项进行安全操作,任何用户违反使用手册及注意事项而产生的相关法律事项本公司不负任何法律责任,任何因误操作而导致产品损坏不知本公司保修范围内。

   

2. 本产品的镭射危险等级为CLASS III A , 任何违反此等级使用要求而产生对人体的损害本公司不会负法律责任。

 

Operating Instructions
1, connected to DC12/2A power, press the Power ON / OFF, 2 seconds later by laser ON / OFF
 
2, MP3 Play / Pause: Press the first time "mp3 play / stop" button to play MP3 music; second pause at the current music player, press the INPUT button to receive the second multi-channel radio, FM with a play on / Xiashou Music
key, remote radio tune.
      
3, by operation of play on the player / Xiashou music.
     
4, the points are fast moving, press the button for the first time, MP3 sound control mode (the laser will flash with the rhythm of the music)
     
5, USB: products through the USB cable, copy MP3 music data (which can be as U disk to use) the external system interface, 3.5 mm audio input
      
6, the remote control: using the remote control is required on the remote at the remote receiver products, effective control of about 10 meters away from the product on the remote control receiver to receive an effective angle of 15 degrees, beyond this point will affect remote effects; use the remote control to adjust the volume, the need to sound the product volume to maximum, so as to normal remote volume.
     
7, for the first time using the remote control, the need to remove the transparent pad before use.
     
Use of premises for
Family birthday party, wedding party and other celebrations KTV disco to create a romantic atmosphere with entertainment.
     
Product Specifications
1, Product Dimensions: 19.5 * 15.5 * 24.5CM Color Box Dimension: 42 * 25 * 38CM Weight: 1.8KG
    
2, packing parts: (1) Music Stage Light 1 set (2) AC power of a (3) a remote control (4) a manual (5) audio cable, power cord of the 1
    
3, power supply: Input 100 ~ 240V AC 50/60Hz, Output: 5V DC 1.5A, used car ignition power, and motorcycle 12V power input.
    
4, speaker: 3 half inches wide-band, 2 inch tweeter
    
5, Speaker Power: 15W
                                                                                       
6, the working temperature: +10 ° ~ +40 degrees
   
7, storage temperature: -10 degrees to +60 degrees
 
Often the fault handling
1, fuzzy spot stars: Please use a cotton swab to gently wipe the lens optical port.
    
2, press the play without sound: by turn off the power ON / OFF, turn the power on again, ON / OFF, 3 seconds later open the music player key, and then adjust the volume control key state in the middle or to the loudest.
    
Notes
1. Strictly manual operation as described in the product, do not disassemble the warranty.
    
2. Please note that when using this product waterproof shock and not in the dusty environment, the laser's normal working environment temperature is 10 ~ 40 degrees, beyond this temperature range, the laser light may be an exception.
    
3. Please do not look directly at the laser light, avoid the use of observation equipment and optical devices afar laser light source, to prevent the increased risk.
    
Statement
1. So the user must comply with all manuals and precautions for safe operation, violations of any user manual and pay attention to matters related to legal issues arising from the Company assumes no liability for any product damage caused due to misuse do not know the warranty of the Company range.
    
2. The product of the laser risk rating CLASS III A, the requirement of any breach of this level of damage caused to the human body will not be liable for the company.

反对 0举报 0 收藏 0 评论 0
更多>本企业其它产品
网站首页  |  关于我们  |  服务条款  |  广告合作  |  付款方式  |  使用协议  |  联系我们  |  网站地图  |  排名推广  |  广告服务  |  网站留言  |  RSS订阅  |  违规举报